Sat, 18 Mar 2000 20:14:24 -0700 - "Joseph A. DiVerdi" <diverdi@XTRsystems.com> writes: >I am sorry to report that I screwed up the tarring/gzipping operation >used to create the Mac::Serial distribution file. I have made the >StuffIt archive available on my home page (as noted in the signature >below) for all of those who are interested in accessing those serial >ports. > >Sorry for the static. ---------------------------------------------------------------------------= ----- ------------------- When I loaded MacPerl the site_perl folder never was created Instead the following folders were created (typical to the MacPerl =9F show= n in my tattered MPPE) MacPerl =9F:lib: MacPerl =9F:lib:Mac The library preference points to MacPerl =9F:lib: your ReadMe file states: INSTALLATION To install this library, make an alias of the Serial.pm file and put it into the :site_perl:Mac folder in your MacPerl folder. You can also put the Serial v1.x folder in the site_perl folder for convenience but it is not required. Run the test program (master.t) located in the t folder to verify proper operation. I installed your Serial.pm in the lib instead of the site_perl folder HD:MacPerl =9F:lib:Serial:Serial.pm HD:MacPerl =9F:lib:Mac:Serial.pm <--alias running the syntax check on the Serial.pm and the master.t my results were: # HD:MacPerl =9F:lib:Serial:Serial.pm syntax OK 1..29 # Tsunami:MacPerl =9F:lib:Serial:t:master.t syntax OK not ok 1 the results for master.t looks like Serial.pm didn' t load? Is there an alternative to installing? or should I create site_perl with mac as a sub-folder? perhaps you could help me thought the screaming syntax checker results!! "not ok 1" BTW thanks for all of your hard work creating Serial.pm TIA David # =3D=3D=3D=3D=3D Want to unsubscribe from this list? # =3D=3D=3D=3D=3D Send mail with body "unsubscribe" to macperl-request@macp= erl.org